Exocomp

File:Exocomb withtool.jpg

An exocomp with a mode stabilizer

Exocomps were sentient artificial lifeforms designed by Dr. Farallon.

Origins

Farallon began working on an exocomp prototype several years before 2369, until she had three working units in operation at the Particle Fountain Project for maintenance purposes. The exocomp was not intended to be sentient, but due to the adaptive nature of its design it evolved, gaining sentience.

The basis of the exocomp was an industrial servo mechanism which had been in common use on Tyrus VIIa for many years. This basic design was extended by Dr. Farallon who named them 'exocomps'. The main design goal was to make the exocomp a problem-solver.

Design

Inside an exocomp

The exocomp consisted of a micro replicator, a boridium power converter and axionic chip network. This axionic network gave the exocomp formidable computational power. The micro replicator not only created tools which the exocomp could use to solve problems but also created new circuit pathways in the exocomps memory when it performed new tasks. This mechanism gave the exocomp the ability to learn. The more tasks it had to perform, the more pathways were formed in its memory.

Problems to be solved could be entered through a command-pad, after which the exocomp decided what kind of tool it had to use and then replicated that tool.

Recognition of Sentience

Lieutenant Commander Data was testing an exocomp on the particle fountain and completed fourteen separate tests when the device was sent into an access tunnel to seal a plasma conduit. The exocomp returned without finishing its task. When Dr. Farallon tried to send it back into the access tunnel by overriding the exocomp commands, her control pad overloaded. A few seconds later the plasma conduit exploded. If the exocomp had returned to the access tunnel, it would have been destroyed.

An exocomp's circuit pathways

When Data brought the exocomp back to the USS Enterprise-D for analysis, it was found that the exocomp had shut down and that the interface circuitry which connected the exocomp to the control pad was completely burned out. Further investigation revealed that the number of new circuit pathways had increased by 632 percent. Dr. Farallon explained that sometimes an exocomp randomly generated large numbers of new pathways, which ultimately led to a total shutdown. When this happened the exocomp became totally useless and had to be erased and reprogrammed all over again. Data mentioned that the new pathways did not to appear to interfere with the original circuitry. This led Lieutenant Commander La Forge to comment that somehow the exocomp knew that the conduit would explode and therefore it had to leave the access tunnel. Because this remark would imply some form of self-preservation, Data took it upon him to perform a level one diagnostic on the exocomp.

The diagnostic Data performed revealed that the command module was working normally. When checking the exocomp's sensor logs it turned out that the exocomp had burned out its own command interface circuitry and then repaired it two hours later. In a short briefing it was decided to test whether the exocomp possessed a survival instinct or not.

An exocomp being tested

A test was created where an exocomp had to repair a small conduit breach in a Jefferies tube in which a plasma cascade failure was simulated by means of a transient overload signal. The exocomp performed the repair and was returned after the plasma overload simulation would have destroyed it. Data performed thirty-four additional tests and all tests had the same outcome. Every single time the exocomp would complete the repairs. Because Doctor Crusher distracted Data from his latest test, the exocomp returned automatically and Data noticed it had a different tool than when it entered the tube. In the previous tests the exocomp was recalled when the simulated plasma overload would have occurred. When Data checked the sensor logs he discovered that the exocomp had deactivated the overload signal. It had not failed the test; it had seen right through it.

When the situation on the particle fountain went critical the decision was made to reconfigure the exocomps so their power cells would explode when beamed into the particle matter stream but because of their survival instincts the command pathways would have to be disconnected. Data locked out the transporter controls preventing the exocomps from being transported because he did not believe that it was justified to sacrifice one lifeform for another. Commander Riker proposed to ask the exocomps if they were willing to perform this mission, when their command pathways were reconnected they reprogrammed the commands Data had entered and altered the transporter coordinates to send them inside the station core, instead of the matter stream. They solved the problem by distorting the particle stream frequency. Unfortunately, one of the exocomps did not survive, as it had to stay behind to disrupt the particle stream so the other two could safely be beamed back to the Enterprise.

At last report, Dr. Farallon was trying to find out what the exocomps really were without treating them as simple tools. (TNG: "The Quality of Life")

Background

• According to the Star Trek Encyclopedia, "the exocomps, designed by Rick Sternbach, were very loosely based on the character Nammo from the animated science fiction series The Dirty Pair."
• Parts of the exocomp studio model came from the AMT/Ertl D7 class model kit.
• The exocomp prop was modified for re-use in Star Trek: Enterprise's "Dead Stop" ten years later.

This is a featured article. At the time it was featured, it was considered one of the best examples of the Memory Alpha community's work. If you see a way this page can be improved further though, we invite you to contribute.

---

Revision ID missing! • Date missing! • Blurb